Five materials in stock
We print with Bambu Lab filaments, each material with a proven profile. More choice does not make quotes better, only slower.
PLA
€0.08/g · 12 colours in stock
The standard for visible parts, models and prototypes. Stiff, dimensionally accurate, very good surface. Not for above 55 °C or permanent outdoor use.
Datasheet →PETG
€0.10/g · 8 colours in stock
For parts under load: brackets, housings, clips, adapters. Tougher than PLA, holds up to 75 °C, slightly glossy.
Datasheet →TPU 95A
€0.14/g · 4 colours in stock
Flexible like a hard rubber. Seals, feet, cases, dampers, belts. Slow to print, hence more expensive.
Datasheet →ASA
€0.12/g · 5 colours in stock
For outdoors: UV-stable, weatherproof, up to 95 °C. The material for garden tools, bikes, balconies and cars.
Datasheet →PLA-CF
€0.16/g · Black
Carbon-fibre reinforced PLA: very stiff, deep matte black surface, no visible layers. For visible parts with a technical look.
Datasheet →On request
PA, PC, PETG-CF, wood, silk, glow
Ordered for your job, lead time +3 working days. Colours from the Bambu Lab range.
Which material for which part
| Requirement | Recommendation | Why |
|---|---|---|
| Visible part, model, decor | PLA | best surface and detail, cheapest |
| Under load, gets assembled | PETG | tough, snap fits do not break |
| Heat above 60 °C, car, sun | ASA | up to 95 °C, UV-stable |
| Flexible, seal, protection | TPU 95A | stretchy, tear-resistant |
| Stiff and refined, technical look | PLA-CF | twice as stiff, no layer lines |
| Food contact | on request | dedicated filament and nozzle needed |
Colours
PLA: white, black, grey, red, blue, green, yellow, orange, beige, silver, bronze, natural. PETG: black, white, grey, transparent, blue, red, green, orange. TPU: black, white, grey, red. ASA: black, white, grey, blue, red. Special colours are ordered for jobs from €25 at no extra charge, lead time +3 working days.
Layer height and infill
0.20 mm is the standard: good surface, sensible time. 0.12 mm for figures and lettering, 0.08 mm for miniatures. 0.28 mm for large parts with no visual demands. Infill sets weight and strength: 15 % for decor, 30 % for almost everything, 50 % for brackets under load, 100 % for gears and parts that get machined afterwards.
Material chosen?
The calculator shows at once what the difference costs.